A branch lead trims installation time when it fits the project design and arrives with each branch properly identified. The factory needs more than an illustration of a Y-shaped cable. It needs the circuit topology, branch lengths, conductor sizes, exact connector models and maximum electrical demand on each section. Establish protection and equipment limits with the project’s electrical designer before sourcing the assembly.
Set branch measurements from an agreed point
Use the engineering drawing to set the measurement point for each leg and the location of clips, sleeves or labels. Include intended routing and any constraints at the enclosure entry. A dimension that begins at a connector tip will be longer than a dimension measured from the end of the overmould. Make the drawing explicit so sample and line measurements use the same reference.
Validate a harness as a complete assembly
Ask the Vietnam factory which checks apply to each assembly and which require sample testing. The buyer may specify continuity and polarity for every unit, along with a separate verification of the junction design and environmental performance. Include the precise mating connectors in the sample review. TGS can review the production drawing for custom lengths and branch layout as part of an assembly enquiry.
Discuss your cable order with TGS
TGS manufactures power cords and power cables in Vietnam for international buyers. Our team can review the cable build, connector assembly and export packaging together. See our custom cable and harness capabilities if you are sourcing a build to drawing.
Send a factory enquiry for a finished cord or custom build. Use the quotation tool for supported bulk cable sizes. Email ken@tgscable.com, call (+84) 868 848 620 or connect on WhatsApp, Zalo or WeChat.
