An Ethernet lead routed outside may see sun, heat, cold and moisture. A buyer should provide the conditions for the whole route, including any portion transitioned indoors. Select the jacket together with the mounting and termination requirements. Confirm that the electronics and mating connector arrangement are suitable for the installed conditions. A jacket declaration covers the jacket characteristics specified in that declaration.
Draw the environment at each end
Mark where the cable passes through a wall or enclosure and where it enters the device. State required UV or wet-location evidence and any indoor cable requirements that apply to the same run. If an exposed terminal relies on an accessory specified by its maker, use the prescribed connection for that terminal. For a downstream custom cable, ask the engineering team what enclosure, seal and retention are needed.
Check the complete assembly
Arrange sample review with the Vietnam manufacturer using the actual enclosure or mating hardware. Confirm bend and release clearance and set the environmental tests with the engineering team. Have the supplier describe how finished lengths, tooling and labels correspond to the approved build. This makes it possible to compare like-for-like quotes on a long outdoor network installation.
Discuss your cable order with TGS
TGS manufactures power cords and power cables in Vietnam for international buyers. Our team can review the cable build, connector assembly and export packaging together. See our custom cable and harness capabilities if you are sourcing a build to drawing.
Send a factory enquiry for a finished cord or custom build. Use the quotation tool for supported bulk cable sizes. Email ken@tgscable.com, call (+84) 868 848 620 or connect on WhatsApp, Zalo or WeChat.
