The space behind a wall-mounted display can change between installations even when the television model stays the same. A flush bracket can leave only a narrow path for the cord, while a tilt mount may allow a cable to pass freely until the screen moves. Specify the assembly with the expected bracket and movement in view.
A recess can require a connector to move straight in for several millimeters before it seats. When an angled shell touches the enclosure during that motion, the cord may look like it fits from a side view while stopping short of full insertion. Check the complete insertion path on the sample.
Draw the right angle from the mating face
A direction callout such as left elbow can be interpreted differently depending on which side of the connector the viewer faces. Mark the direction on a rear view of the display and show the cord exit relative to adjacent ports. Include clearance for the molded body, strain relief and permitted bend. If a cover closes over the inlet, verify the cover on the prototype.
Validate the cable where it will be used
Use the equipment maker’s routing instructions when determining accessible slack behind the screen. A clearance sketch helps the Vietnam factory compare available molds and decide whether a new enclosure-specific tool is needed. Order an approved fit sample before locking unit packs, because the protrusion and winding radius affect both installation clearance and the depth of the packaged SKU.
Discuss your cable order with TGS
TGS manufactures power cords and power cables in Vietnam for international buyers. Our team can review the cable build, connector assembly and export packaging together. See our custom cable and harness capabilities if you are sourcing a build to drawing.
Send a factory enquiry for a finished cord or custom build. Use the quotation tool for supported bulk cable sizes. Email ken@tgscable.com, call (+84) 868 848 620 or connect on WhatsApp, Zalo or WeChat.
