Right-angle power cord requests often describe the desired exit using up, down, left or right. Those words can reverse when the engineer turns the plug over or the equipment is mounted differently. A factory drawing should show which direction the cable leaves when the connector is mated to the equipment and the pin geometry is oriented as shown.
For example, provide the mating view for an equipment-end elbow and a drawing of the back panel with free space shaded. A left exit on the connector drawing can then be confirmed against the actual mounting orientation of the equipment.
Show the footprint around the connector
Give the Vietnam team a photo and a measured view of the inlet, neighboring connectors and fasteners. Include the maximum allowable protrusion and first portion of the cable route. An elbow that clears the cabinet wall may still sit in front of a USB port or block access to a fan latch.
Approve the molded and routed sample
Check the plastic body, strain relief and usable length in the installed position. Confirm which end is angled, whether the existing tool covers that direction and how that option will be labeled for receiving. Include the signed drawing and evidence for the intended assembled rating. This gives the factory a stable reference when the buyer reorders or adds different cord lengths.
Discuss your cable order with TGS
TGS manufactures power cords and power cables in Vietnam for international buyers. Our team can review the cable build, connector assembly and export packaging together. See our custom cable and harness capabilities if you are sourcing a build to drawing.
Send a factory enquiry for a finished cord or custom build. Use the quotation tool for supported bulk cable sizes. Email ken@tgscable.com, call (+84) 868 848 620 or connect on WhatsApp, Zalo or WeChat.
