A cord that fits a desktop monitor on the bench can still fail the packing or installation trial when the connector has to pass through a narrow stand. A supplier might quote the requested length while overlooking the size of the molded shell. Measure the tightest opening and determine which end of the cord passes through it first.

Ask the assembler to route the sample with the screen fully raised and again after rotating it within its rated range. If it binds, use the measured extra length or a revised route to update the drawing before a carton label is printed.

Measure on the full range of motion

Height adjustment, pivot and swing movement change the route. Evaluate the assembly in the extreme positions allowed by the stand instructions, checking slack, pinch points and connector pull. Record the length between reference points using a routed sample. If the stand uses clips, check the maximum jacket diameter the clip accepts without damage.

Use the smallest practical set of options

A large fleet may be able to use two lengths for multiple monitor models if the inlet, cord rating and routed fit have been verified. Keep a measured route for each approved stand and choose an exit shape only after evaluating the entire insertion path. When requesting a quote from Vietnam, supply the desired reference length and tolerance so you can compare finished assemblies, rather than cable cut lengths measured before they enter the molding line.

Discuss your cable order with TGS

TGS manufactures power cords and power cables in Vietnam for international buyers. Our team can review the cable build, connector assembly and export packaging together. See our custom cable and harness capabilities if you are sourcing a build to drawing.

Send a factory enquiry for a finished cord or custom build. Use the quotation tool for supported bulk cable sizes. Email ken@tgscable.com, call (+84) 868 848 620 or connect on WhatsApp, Zalo or WeChat.

TGS CABLE in Yellow Page · TGS Cable In KOMPASS