Two offers can show a cord length of two metres while measuring different portions of the assembly. One may quote cable cut length. Another may measure between the device-end and plug reference faces. Buyers should define the length that matters to the installed product before comparing price or asking for a tolerance.

When the assembly has an unusually large boot, make a marked reference sample available on a flat bench. A consistent method for placing and measuring the sample helps a buyer distinguish a short cord from a difference in measurement approach.

Choose a datum suited to the installation

Use a simple side view of the completed cord to identify both measuring points. For elbow shapes, note whether the dimension follows the cable or is taken between reference planes. If a grommet or terminal is part of the finished assembly, mark whether that component falls inside the measured span. Include the inspection method so production and receiving can repeat the measurement.

Translate tolerance into an acceptance decision

Check the shortest permitted sample for route reach and the longest for packing and excess slack. A Vietnam manufacturer can estimate how its cut length and molded ends contribute to the final dimension. Make the final assembly tolerance a purchasing condition, linked to the approved drawing and samples, so subsequent batches can be verified at the warehouse bench.

Discuss your cable order with TGS

TGS manufactures power cords and power cables in Vietnam for international buyers. Our team can review the cable build, connector assembly and export packaging together. See our custom cable and harness capabilities if you are sourcing a build to drawing.

Send a factory enquiry for a finished cord or custom build. Use the quotation tool for supported bulk cable sizes. Email ken@tgscable.com, call (+84) 868 848 620 or connect on WhatsApp, Zalo or WeChat.

TGS CABLE in Yellow Page · TGS Cable In KOMPASS