A Canadian project may call for a nonmetallic cable on a route where moisture is expected. Confirm the precise NMWU designation and the permitted installation conditions with the project designer. Compare the full cable proposal against the specification, including conductor arrangement, dimensions and any protection needed where the cable enters equipment.

Identify the sections that create the requirement

Mark the route as a drawing, including where it leaves a building, passes through a wet space or ends at a junction. List cable sizes, ground or bond layout, outside dimensions and expected lengths. Ask the supplier to identify the offered jacket marking and approval evidence for the exact cable. Check the requirements for connector and gland fit with the appointed installer.

Ask the project team to label moisture exposures separately from the intended installation method. A cable in a wet space and a cable placed beneath the soil can face different approval requirements. Include the measured run and actual fitting layout for each location.

Decide how receiving will verify the product

Request a sample and pack label before the first order. If the same project also needs NMD90, give the two types separate order positions so a similar gauge cannot be picked incorrectly. Review TGS NMWU configurations and provide the Canadian destination and project drawing for a quote from Vietnam.

Discuss your cable order with TGS

TGS manufactures power cords and power cables in Vietnam for international buyers. Our team can review the cable build, connector assembly and export packaging together. See our custom cable and harness capabilities if you are sourcing a build to drawing.

Send a factory enquiry for a finished cord or custom build. Use the quotation tool for supported bulk cable sizes. Email ken@tgscable.com, call (+84) 868 848 620 or connect on WhatsApp, Zalo or WeChat.

TGS CABLE in Yellow Page · TGS Cable In KOMPASS