A nominal outside diameter gives a starting point when buying a gland or clamp. The minimum and maximum cable diameters determine fit across production lots. A gland may need the stated diameter range for tension relief and sealing, or may require a special insert. Have engineering evaluate the approved combination for the actual enclosure and exposure.

Set dimensions on the same drawing

Send the cable and equipment entry drawings together. Specify tolerance, geometry, jacket material if prescribed and any restrictions on routing close to the entry. If the cable is oval or has a textured jacket, document how measuring is done. Confirm which dimensions are directly controlled in the quote.

If a gasket or relief interface is sensitive to temperature, ask the equipment team to specify the relevant sample conditions. Check sealing and retention under that agreed method. Document which diameter and jacket revision were used, so approval can be repeated for a new lot.

Request evidence from an approved pilot

Measure samples and check installation with the approved hardware, especially near the extremes specified. Keep the gland part number and cable revision linked in the test record. Tell the TGS factory enquiry team the required rotation, mounting depth and environmental conditions where applicable so the Vietnam proposal accounts for the full interface.

Discuss your cable order with TGS

TGS manufactures power cords and power cables in Vietnam for international buyers. Our team can review the cable build, connector assembly and export packaging together. See our custom cable and harness capabilities if you are sourcing a build to drawing.

Send a factory enquiry for a finished cord or custom build. Use the quotation tool for supported bulk cable sizes. Email ken@tgscable.com, call (+84) 868 848 620 or connect on WhatsApp, Zalo or WeChat.

TGS CABLE in Yellow Page · TGS Cable In KOMPASS