In a multi-drive enclosure, cable strain can build up because several closely spaced plugs must meet a fixed tray. Draw the route with the trays installed, and keep the last connector accessible for service. The same drawing should identify the power supply revision and the number of drives expected to start at once.

Specify both ends of the harness

The drive connector follows the device interface. The modular side of a power supply can use manufacturer-specific wiring, even among units with a similar-looking socket. Obtain the approved pin assignment for the exact PSU and include every position on the drawing. Check startup current and the expected load across the harness with the equipment team. SATA power and SATA data use separate cables or connector functions, so list them separately in the pack plan.

Test each trunk and branch

Inspect connector spacing, latch fit and retention on a dressed assembly routed through the chassis. Set a pin-to-pin electrical test that catches shorts, swapped positions and omitted wires. For a Vietnam cable assembly quotation, send TGS the pinout, mating drawings and exact tray geometry. That lets sourcing compare construction and tooling against the same fit and load requirements.

Discuss your cable order with TGS

TGS manufactures power cords and power cables in Vietnam for international buyers. Our team can review the cable build, connector assembly and export packaging together. See our custom cable and harness capabilities if you are sourcing a build to drawing.

Send a factory enquiry for a finished cord or custom build. Use the quotation tool for supported bulk cable sizes. Email ken@tgscable.com, call (+84) 868 848 620 or connect on WhatsApp, Zalo or WeChat.

TGS CABLE in Yellow Page · TGS Cable In KOMPASS